Featured
Hunter Sprinkler System Manual Start
Hunter Sprinkler System Manual Start. · unscrew it to remove it. Close any other valves to the outside (including sprinklers) and begin pressurizing the system.once the system is pressurized, run through the stations one by one, letting each station operate for two minutes.
This guide is intended to be used when designing and installing small single family residential sprinkler systems. If this is the first system you have installed, or if you have installed several systems but have never used this. This guide is intended to be used when designing and installing small single family residential sprinkler systems.
Sprinkler System Design Capacity B.
Allows the user to activate the station manually 12. In this regard also, to figure out if this is the cause, you will have to use a multimeter. If any of the above problems aren’t seem to be the reason behind your sprinkler system not turn on, then most probably your controller doesn’t have enough voltage.
To Program Properly, The Days Should Be Shown As Follows:
If any of the above problems aren’t seem to be the reason behind your sprinkler system not turn on, then most probably your controller doesn’t have enough voltage. 4 per program, three programs for up to 12 starts watering schedule: The steps to programing a hunter sprinkler system begin and end at the controller.
Courtesy Of Hunter Industries Inc.
This will switch the display on the controller to days of the week. Simply turn the dial to “current time/day” and use the directional buttons above until you see the correct day and time on the display. Residential sprinkler system design guide 5 sprinkler system capacity working pressure psi 25 30 35 45 50 55 note:
While Holding The Nozzle Turret At The Right Stop, Turn The Wrench Clockwise.
Check whether the voltage of the controller. With this setting, you designate how long you would like the sprinklers to run before automatically shutting off. If this is the first system you have installed, or if you have installed several systems but have never used this.
A Water Droplet Icon Indicates A Day That You Want Your Sprinklers To Run.
Use the left and right arrows to cycle through the days. Turn the dial again to “run times”. This guide is intended to be used when designing and installing small single family residential sprinkler systems.
Popular Posts
Best Way To Get Cocaine Out Of Your System
- Get link
- X
- Other Apps
Comments
Post a Comment